Jensen heritage for the next generation

EARLY JENSEN INTERCEPTOR CABRIOLET BROCHURE £65

Item description: Early Jensen Interceptor Cabriolet brochure dating from September 1951. Various images of Jesnen Cabriolet registered ‘GEA 5’.

 

 

Condition report: Generally clean. Free from folds.

 

Notes:

The Jensen Interceptor made its debut in 1950 as the second car made by Jensen Motors after World War II. The car was based on Austin components with a body built by Jensen and styled by Eric Neale. The 3,993 cc (4.0 L; 243.7 cu in) straight-six engine and transmission came from the Austin Sheerline and the chassis was a lengthened version of the one used on the Austin A70 with a modified version of the independent coil sprung suspension.

 

Production continued through 1957. Jensen later reused the name for a second-generation Jensen Interceptor which debuted in 1966 and was revived several times after that.

 

The two door Interceptor first appeared as a convertible bodied in a mix of aluminium and steel on a wood frame. The entire front section hinged forwards to give access to the engine. The wrap around rear window was made of rigid plastic (Perspex) and was arranged to drop down into a well for stowage when the top was lowered. In 1952 a hardtop version with fabric-covered roof was launched and a few sedanca version were also made. Total production was 32 convertibles, 52 saloons and 4 sedancas.

 

The brakes used a mixed Girling hydraulic/mechanical system at first to be replaced by a full hydraulic system later. The four speed manual transmission gained optional overdrive in 1952. When the overdrive was fitted a lower, 3.77:1, rear axle gearing was used.

 

A convertible tested by The Motor in 1952 had a top speed of 95 mph (153 km/h) and could accelerate from 0-60 mph (97 km/h) in 17.8 seconds. A fuel consumption of 20.3 miles per gallon(imperial) was recorded. In 1952 the car cost £2645 (including tax) on the home market. The overdrive was an extra £116.

 

In 1953 American race car legend Briggs Cunningham had a left hand drive Interceptor made with a 331 cu in (5.4 L), 180 bhp (134.2 kW) Chrysler “Firepower” hemi engine.

 

See http://www.jensenmuseum.org/jensen-production-figures-dates/ for further information about the early Jensen Interceptor.

 

Provenance: From Andrew Edwards, former owner Cropredy Bridge Garage 1972 – 1995.

 

Ordering: shop@jensenmuseum.org or telephone: +1694-781354